Where diversion ditches are specified to be lined with rip-rap or granular it shall be according to OPSS 1004.
805.07.09 Sediment Traps for Dewatering
Sediment traps for dewatering shall be constructed as specified in the Contract Documents.
Sediment traps for dewatering shall be constructed a minimum of 30 m away from waterbodies or as far away as practicable from the top of the bank of any waterbody.
The shape of the excavated basin may be varied to suit the characteristics of the area surrounding it.
The sediment barrier and rock flow check dam shall be constructed as specified in the Contract Documents.
Construction of the sediment barrier shall be according to the requirements for light-duty sediment barriers with the following exceptions:
-
End runs are not required.
-
The rock flow check dam shall be located at the low point of the light-duty sediment barrier.
A temporary fence shall be erected around the sediment trap to restrict public access.
Discharge of water from sediment traps for dewatering shall be according to OPSS 518.
805.07.10 Filter Bags
Filter bags, hoses and pumps shall be sized appropriately to the volume as specified in the Contract Documents of water to be filtered. Bags shall have a FOS as specified in the Contract Documents.
Filter bags shall be situated in a vegetated area or placed on a permeable surface on a slight slope with the opening of the bag facing upslope a minimum of 30 m away from waterbodies or as far as practicable from the top of the bank of any waterbody.
The opening of the filter bag shall be securely attached with mechanical connections to the discharge hose using commercially available hose couplers and placed in the retention facility to be dewatered.
Discharge of water from filter bags shall be according to OPSS 518.
805.07.11 Turbidity Curtains
Turbidity curtains shall be constructed as specified in the Contract Documents. Turbidity curtains shall be free of tears and gaps, and the bottom edge of the curtain shall be continuously in contact with the waterbody bed so that sediment passage from the enclosed area is prevented.
Turbidity curtains shall be constructed according to the following:
- Breaks may be made in the lower sleeve to facilitate pulling of the ballast, provided they are a maximum 100 mm in size and spaced at minimum 3 m intervals.
-
Where turbidity curtain geosynthetic is joined to provide a continuous run, the sections shall be connected to provide a continuous seal to prevent the escape of turbid water between the sections.
-
The turbidity curtain shall be of sufficient width to account for water depth and wave action.